单项选择题

Refer to the exhibit.What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown？（）

A.The Seria l0/0interface is passing traffic.
B.The DLCI 100 was dynamic allyallocated by the router
C.The Seria l0/0 interf aceacquired the IP address of 172.16.3.1 from a DHCP server
D.The DLCI 100 will be dynamically changed as required to adapt to changes in the Frame Relay cloud
E.The mapping between DLCI 100 and the end station IP address 172.16.3.1 was learned through Inverse ARP

<上一题目录下一题>

热门试题

多项选择题Which of the following are key characteristics of PPP?（）

A.can be used over analog circuits
B.maps Layer 2 to Layer 3 address
C.encapsulates several routed protocols
D.supports IP only
E.provides error correction

单项选择题A default Frame Relay WAN is classified as what type of physical network?（）

A.point-to-point
B.broadcast multi-access
C.nonbroadcast multi-access
D.nonbroadcast multipoint.broadcast point-to-multipoint

单项选择题Refer to the exhibit.Which statement describes DLCI 17?（）

A.DLCI 17 describes the ISDN circuit between R2 and R3.
B.DLCI 17 describes a PVC on R2.It cannot be used on R3 or R1.
C.DLCI 17 is the Layer 2 address used by R2 to describe a PVC to R3.
D.DLCI 17 describes the dial-up circuit from R2 and R3 to the service provider.

单项选择题The following configuration line was added to router R1 Access-list 101 permit ip 10.25.30.00.0.0.255 any What is the effect of this access list configuration?（）

A.ermit all packet smatching the first three octets of the source address to all destinations
B.permit all packet matching the last octet of the destination address and accept all source addresses
C.permit all packet matching the host bits in the source address to all destinations
D.permit all packet from the third subnet of the network address to all destinations

单项选择题Priorto802.1w，Ciscoimplementedanumberofproprietaryenhancementsto802.1DtoimproveconvergenceinaLayer2network.Whichstatementiscorrect？（）

A.Only UplinkFast and BackboneFast are specified in 802.1w；PortFast must be manually configured.
B.Only PortFast is specified in 802.1w；UplinkFast and BackboneFast must be manually configured.
C.None of the proprietary Cisco enhancements are specified in 802.1w.
D.PortFast，UplinkFast，and BackboneFast are specified in 802.1w.