单项选择题

Refer to the exhibit.Which statement describes DLCI 17?（）

A.DLCI 17 describes the ISDN circuit between R2 and R3.
B.DLCI 17 describes a PVC on R2.It cannot be used on R3 or R1.
C.DLCI 17 is the Layer 2 address used by R2 to describe a PVC to R3.
D.DLCI 17 describes the dial-up circuit from R2 and R3 to the service provider.

<上一题目录下一题>

热门试题

单项选择题The following configuration line was added to router R1 Access-list 101 permit ip 10.25.30.00.0.0.255 any What is the effect of this access list configuration?（）

A.ermit all packet smatching the first three octets of the source address to all destinations
B.permit all packet matching the last octet of the destination address and accept all source addresses
C.permit all packet matching the host bits in the source address to all destinations
D.permit all packet from the third subnet of the network address to all destinations

单项选择题Priorto802.1w，Ciscoimplementedanumberofproprietaryenhancementsto802.1DtoimproveconvergenceinaLayer2network.Whichstatementiscorrect？（）

A.Only UplinkFast and BackboneFast are specified in 802.1w；PortFast must be manually configured.
B.Only PortFast is specified in 802.1w；UplinkFast and BackboneFast must be manually configured.
C.None of the proprietary Cisco enhancements are specified in 802.1w.
D.PortFast，UplinkFast，and BackboneFast are specified in 802.1w.

单项选择题OnthebasisofthedefinitionsofdifferentservicesinvariousRFCs，trafficwithExpeditedForwardingper-hopbehaviorshouldbemarkedaswhichofthese？（）

A.IP ToS of 0xEF
B.IP experimental ECN
C.DSCP decimal 5
D.Binary value of 101110

单项选择题WhichistheresultofenablingIPSourceGuardonanuntrustedswitchportthatdoesnothaveDHCPsnoopingenabled？（）

A.DHCP requests will be switched in the software， which may result in lengthy response times.
B.The switch will run out of ACL hardware resources.
C.All DHCP requests will pass through the switch untested.
D.The DHCP server reply will be dropped and the client will not be able to obtain an IP address.

多项选择题WhichthreestatementsaretrueaboutSourceSpecificMulticast？（）

A.Is best suited for applications that are in the one-to-many category.
B.SSM uses shortest path trees only.
C.The use of SSM is recommended when there are many sources and it is desirable to keep the amount of mroute state in the routers in the network to a.
D.There are no RPs to worry about.