多项选择题

Refer to the exhibit. What will Router1 do when it receives the data frame shown?（）

A.Router1 will strip off the source MAC address and replace it with the MAC address 0000.0c36.6965.
B.Router1 will strip off the source IP address and replace it with the IP address 192.168.40.1.
C.Router1 will strip off the destination MAC address and replace it with the MAC address 0000.0c07.4320.
D. Router1 will strip off the destination IP address and replace it with the IP address of 192.168.40.1.
E.Router1 will forward the data packet out interface FastEthernet0/1.
F.Router1 will forward the data packet out interface FastEthernet0/2.

<没有了目录下一题>

热门试题

多项选择题What are three features of the IPV6 protocol?（）

A.complicated header
B.plug-and-play
C.no broadcasts
D.checksums
E.optional IPsec
F.autoconfiguration

多项选择题Refer to the exhibit. Which three statements correctly describe Network Device A（）

A.With a network wide mask of 255.255.255.128, each interface does not require an IP address.
B.With a network wide mask of 255.255.255.128, each interface does require an IP address on a unique IP subnet.
C.With a network wide mask of 255.255.255.0, must be a Layer 2 device for the PCs to communicate with each other.
D.With a network wide mask of 255.255.255.0, must be a Layer 3 device for the PCs to communicate with each other.
E.With a network wide mask of 255.255.254.0, each interface does not require an IP address.

单项选择题Users on the 172.17.22.0 network cannot reach the server located on the 172.31.5.0 network.The network administrator connected to console port,issued the show ip route command,and was able to ping the server.Based on the output of the show ip route command topology shown in the graphic,what is the cause of the failure?（）

A.IP routing is not enabled
B.A static route is configured incorrectly
C.The network has not fully converged
D.The FastEthernet interface on Coffee is disabled
E.The routing table on Coffee has not updated
F.The neighbor relationship table is not correctly updated

多项选择题Refer to the graphic. R1 is unable to establish an OSPF neighbor relationship with R3. What are possible reasons for this problem?（）

A.All of the routers need to be configured for backbone Area 1.
B.R1 and R2 are the DR and BDR, so OSPF will not establish neighbor adjacency with R3.
C.A static route has been configured from R1 to R3 and prevents the neighbor adjacency from being established.
D.The hello and dead interval timers are not set to the same values on R1 and R3.
E.EIGRP is also configured on these routers with a lower administrative distance.
F.R1 and R3 are configured in different areas.

单项选择题Refer to the exhibit a network administrator cannot establish a telnet session with the indicated router at is the cause of this failure?（）

A .A level 5 password is not set
B.The vty password is missing
C.The console password is missing
D.An ACL is blocking Telnet access