Refer to the exhibit a network administrator cannot establish a telnet session with the indicated router at is the cause of this failure?（）

单项选择题Refer to the exhibit. When running EIGRP, What is required for RouterA to exchange routing updates with RouterC?（）

A.As numbers must be changed to match on all the routers.
B.Loopback interface must be configured so a DR is elected.
C.The no auto-summary command is needed on Router A and Router C.
D.Router B needs to have two network statements, one for each connected network.

单项选择题Refer to the exhibit. Which of these statements correctly describes the state of the switch once the boot process has been completed?（）

A.As FastEthernet0/12 will be the last to come up, it will not be blocked by STP.
B.Remote access management of this switch will not be possible without configuration change.
C.More VLANs will need to be created for this switch.
D.The switch will need a different IOS code in order to support VLANs and STP.

单项选择题Select the action that results from executing these commands.（）Switch(config-if)# switchport port-securitySwitch(config-if)# switchport port-security mac-address sticky

A.A dynamically learned MAC address is saved in the startup-configuration file.
B.A dynamically learned MAC address is saved in the running-configuration file.
C.A dynamically learned MAC address is saved in the VLAN database.
D.Statically configured MAC addresses are saved in the startup-configuration file if frames from that address are received.
E.Statically configured MAC addresses are saved in the running-configuration file if frames from that address are received.

多项选择题Which two commands correctly verify whether port security has been configured on port FastEthernet 0 12 on a switch?（）

A.SW1#show swithport port-security interface FastEthernet 0/12
B.SW1# show swithport port-secure interface FastEthernet 0/12
C.SW1# show port-secure interface FastEthernet 0/12
D.SW1#show running-config
E.SW1#show port-security interface FastEthernet 0/12

多项选择题Which can be done to secure the virtual terminal interfaces on a router?（）

A.Administratively shut down the interfaces.
B.Physically secure the interfaces.
C.Configure a virtual terminal password and login process.
D.Enter an access list and apply it to the terminal interfaces using the access-class command.
E.Create an access list and apply it to the terminal interfaces using the access-group command.