Refer to the exhibit.Statements A,B,C,and D of ACL 10 have been entered in the shown order and appled to interface E0 inbound,to prevent all hosts(except those whose addresses are the first and last IP of subnet 172.21.1.128/28) from accessing the network.But as is,the ACL dose not restrict anyone from the network.How can the ACL statements be re-arranged so that the system works as intended?（）

单项选择题Which statement is correct regarding the operation of DHCP?（）

A.A DHCP client uses a ping to detect address conflicts.(ARP)
B.A DHCP server uses a gratuitous ARP to detect DHCP clients.
C.A DHCP client uses a gratuitous ARP to detect a DHCP server.
D.If an address conflict is detected, the address is removed from the pool and an administrator must resolve the conflict.
E.If an address conflict is detected, the address removed from the pool for an amount of time configurable by the administrator.
F.If an address conflict is detected, the address is removed from the pool and will not be reused until server is rebooted.

单项选择题Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?（）

A.data link layer
B.application layer
C.access layer
D.session layer
E.network layer

多项选择题Refer to the exhibit. The two connected ports on the switch are not turning orange or green. What would be the most effective steps to troubleshoot this physical layer problem?（）

A.Ensure that the Ethernet encapsulations match on the interconnected router and switch ports.
B.Ensure that cables A and B are straight-through cables.
C.Ensure cable A is plugged into a trunk port.
D.Ensure the switch has power.
E.Reboot all of the devices.
F.Reseat all cables.

单项选择题Which port state is introduced by Rapid-PVST?（）

A.learning
B.listening
C.discarding
D.forwarding

单项选择题Refer to the exhibit.HostA cannot ping HostB.Assuming routing is properly configured,what could be the cause of this problem?（）

A.HostA is not on the same subnet as its default gateway
B.The address of SwitchA is a subnet address
C.The Fa0/0 interface on RouterA is on a subnet that cannot be used
D.The serial interfaces of the routers are not on the same subnet
E.The Fa0/0 interface on RouterB is using a broadcast address