A.T10 B.20钢 C.65Mn
单项选择题热加工就是金属在变形过程中再结晶速度()加工硬化速度的塑性加工。
A.小于 B.大于 C.等于
单项选择题在光亮退火过程中,要求入炉的保护气氛露点应低于()。
A.-20℃ B.-40℃ C.-70℃
单项选择题光亮退火时,可以同时进行()。
A.脱碳处理 B.淬火处理 C.正火处理 D.回火处理
单项选择题进行光亮退火时,必须保持炉子的()。
A.通风 B.负压 C.正压 D.密封
单项选择题为降低能源消耗,再结晶退火时,温度应尽可能()。
A.控制的低些 B.控制在Ac1、Accm以上30~50℃ C.控制在再结晶温度以上尽可能低 D.控制在300℃以下
单项选择题现有的45钢制造的汽车轮毂螺栓其淬火冷却介质选择()。
A.20℃水 B.10%食盐水溶液 C.矿物油
单项选择题用45钢制造的凸轮,要求凸轮表面高硬度,而心部具有良好的韧性,应采用()热处理。
A.表面淬火+低温回火 B.渗碳+淬火+低温回火 C.氮化
单项选择题用15钢制造的凸轮,要求凸轮表面高硬度,而心部具有良好的韧性,应采用()热处理。
单项选择题具有引导轧件顺利进入孔形作用的装置是()。
A.导板 B.卫板 C.托板
单项选择题轧机上辊调整装置又称()。
A.压上装置 B.压下装置 C.轴向调整装置