A.沾刀、进刀、试切、测量、进刀到尺寸B.沾刀、测量、进刀、试切、进刀到尺寸C.测量、沾刀、进刀、试切、进刀到尺寸D.沾刀、试切、进刀、测量、进刀到尺寸
单项选择题锥柄连接轴工序20加工,粗车Φ25*19外圆及长度方向各留精车余量()mm。
A.0.5mmB.1mmC.1.5mmD.2mm
多项选择题图样分析可按照()四步完成。
A.形体分析B.技术要求识读C.标题栏识读D.任务栏识读E.精度分析
单项选择题用硬质合金刀具车削薄壁零件时,一般后角取()。
A.4°~12°B.-2°~4°C.-8~-2°D.8~15°
单项选择题螺级千分尺调整时,首先使“微分简”上的零刻线与“固定套管”上的()刻线重合,然后将心轴端“锁紧装置”锁紧。
A.零B.纵C.横D.无
单项选择题粗车循环指令G71,在加工外径是余量U为(),但在加工内轮廓是余量U应为()。
A.正,正B.负,负C.负,正D.正,负
单项选择题细长轴加工由于刀具硬度不够会产生()。
A.圆柱度误差B.腰鼓形C.行节形D.多棱形
单项选择题斜度1:6的画法是:在水平方向取()单位长度,重直方向取()单位长度。
A.3、0.5B.0.5、3C.1、6D.6、1
单项选择题刀尖半径补偿只能在()的运动中建立或取消,即两者要配合使用,且轮廓切削完成要用指令G40取消。
A.G00,G01B.G02,G03C.G71,G70D.G71,G72
单项选择题程序段G92X_Z_F_中的F为()。
A.进给速度B.主轴转速C.切削速度D.导程
单项选择题细长轴工件精加工前进行的人工时效主要作用是()。
A.稳定组织、消除应力B.等待交货期C.无明显作用D.以上均不对