单项选择题

You are configuring an 802.1Q trunk between a Layer 2 switch and a firewall. You read in the documentation that the best way to set up a trunk is to set the port as dynamic desirable. The trunk is not coming up. Which one of these options would be a valid explanation？（）

A.The firewall does not support Cisco Discovery Protocol. You should set the switchport trunk mode ON
B.The firewall does not support Cisco Discovery Protocol. You should set the switchport trunk mode to OFF
C.The firewall does not support Cisco Discovery Protocol. You should set the switchport trunk mode asauto.
D.The firewall does not support DTP. You should set the switchport trunk mode to ON

<上一题目录下一题>

热门试题

多项选择题WhichtwoofthefollowingareconsideredvalidrouterIDsforEIGRPv6？（）

A.0.0.0.1
B.0.255.0.1
C.2001：DB8：：1
D.2001：DB8：ABCD：FEEF：：1

多项选择题Whentroubleshootingduplexmismatches，whichtwoareerrorsthataretypicallyseenonthehalfduplexend？（）

A.excessive collisions
B.FCS errors
C.runts
D.late collisions

多项选择题Whichtwostatementsbestdescribespanning-treeBPDUprocessingforablockingport？（）

A.BPDUs that enter a blocking port are discarded.
B.BPDUs that enter a blocking port are processed.
C.Loopguard puts an interface into a loop-inconsistent state when BPDUs stop being received on a blocking port.
D.BPDUs are only processed on forwarding ports.

多项选择题WhichtwostatementsbestdescribeCBWFQ？（）

A.The CBWFQ scheduler provides a guaranteed minimum amount of bandwidth to each class.
B.CBWFQ services each class queue using a strict priority scheduler.
C.The class-default queue only supports WFQ.
D.Inside a class queue， processing is always FIFO， except for the class-default queue.

多项选择题Whichtwostatementsaretrueabouttheroleofsplithorizon？（）

A.It is a function used by routing protocols to install routes into routing table
B.It is a function that prevents the advertising of routes over an interface that the router is usingto reach a route
C.Its function is to help avoid routing loops.
D.It is a redistribution technique used by routing protocols

You are configuring an 802.1Q trunk between a Layer 2 switch and a firewall. You read in the documentation that the best way to set up a trunk is to set the port as dynamic desirable. The trunk is not coming up. Which one of these options would be a valid explanation？ （）

You are configuring an 802.1Q trunk between a Layer 2 switch and a firewall. You read in the documentation that the best way to set up a trunk is to set the port as dynamic desirable. The trunk is not coming up. Which one of these options would be a valid explanation？（）