A.PowerB.PassiveC.OutputD.Input
单项选择题根据下图的设置,地线的宽度为()mil。
A.30B.不确定C.40D.20
单项选择题布线层的规则设置在以下哪一个规则项中?()
A.Routing LayersB.Short CircuitC.ClearanceD.Routing Width
单项选择题框选下在禁止布线层绘制的板框形状后,点击“设计”菜单中的“板子形状”中的“()”,板框以外的黑色区域会被裁切掉。
A.移动板子形状B.按照选择对象定义C.重新定义板子形状D.根据板子外形生成线条
单项选择题PCB文件中,焊盘和过孔显示在()层。
A.Multi layerB.BottomLayerC.TopLayerD.Mechanical 1
单项选择题在进行原理图的电气规则检查时,出现橙色标记表明()。
A.警告B.错误C.致命错误D.正确
单项选择题为元器件添加封装,可以在打开元件属性对话框后,添加()。
A.FootprintB.Signal IntegrityC.PCB3DD.Simulation
多项选择题进行动态特性的测试,主要应用的方法有()。
A.测试电路动态工作电压B.波形的观察与测试C.频率特性的测试与调整D.电压测试
多项选择题电子产品的检测方法有()。
A.观察法B.测量电阻法C.测量电压法D.波形观察法E.替代法F.信号注入法
多项选择题常用电子产品的调试仪器有()。
A.信号发生器B.万用表C.示波器D.可调稳压电源E.扫描仪F.频谱分析仪G.集中参数测试仪
多项选择题电子产品的调试仪器的选用原则有()。
A.测量仪器的工作误差应远小于被测参数所要求的误差,一般误差要求仪器误差小于被测参数要求的1/10。B.仪器的测量范围和灵敏度,应符合被测量的数值范围。C.调试仪器量程的选择,应满足测量精度的要求。D.测试仪器输入输出阻抗的选择,要符合被测电路的要求。E.仪器输出功率应大于被测电路的最大功率,一般应大一倍以上。F.测试仪器的测量频率范围(或频率响应),应符合被测电量的频率范围(或频率响应)。