Which of the following can we draw from the given information concerning the class-map "all-traffic"?（）

单项选择题Which one of these class maps was configured to match traffic for CS5?（）

A. CIS 1# show class-map forward Class map match-all forward ( id 3) Match ip dscp 18
B. CIS1#show access-map block Class map match-all block (id 4) Match ip dscp 43
C. CIS1# show class-map real-time Class map match-all block (id 5) Match ip dscp 16
D. CIS 1# show class-map pass Class map match-all real-time (id 2) Match ip dscp 40

多项选择题You are an experienced network administrator in an international company. During your working hours, customers complain that they experience intermittent data loss and they intermittently fail to connect to crucial servers. As shown in the following topology, the 802.1Q trunk between DSW111 and ASW1 fails. Though DSW112 is in the service of HSRP group 11, the SVI for VLAN 11 is up on DSW111. So as to figure out the problem, which three commands should you issue on DSW111? （）(Choose three.)

A. show standby vlan 11 brief
B. show interfaces vlan 11
C. show spanning-tree vlan 11
D. show interfaces mod/port trunk

单项选择题You are troubleshooting an issue which is causing full-sized packets entering the MPLS cloud be dropped. You have discovered that one of the switches in the MPLS core is not a Cisco switch, but otherwise the MPLS MTU size is set to 1508 bytes on the routers. Based on this information, which of these may be the reason the packets are being dropped?（）

A. The switch on you MPLS core that was not produced by Cisco does not support oversized packets
B. No switches support oversized packets
C. By definition, the maximum MTU is 1500 bytes
D. As MPLS VPN labeling increases the size of the packet by 8 bytes, the IP MTU should have been changed to 1508

单项选择题Assuming that an IP packet is sent from a source address in VLAN1 to a destination address in VLAN2 through a layer-3 switch, which part of the packet will be changed?（）

A. Layer 2 TTL
B. Layer 3 TTL
C. Layer 3 source address
D. Layer 3 destination address

单项选择题On a Cisco Catalyst 4500 Series, the fail LED is lit for one if its two power supplies. Which command would you use to check on this problem ?（）

A. Show module
B. Show errdisable detect
C. Show environment
D. Show diagnostic content