A network design shows that R1 has four different possible paths from itself to the Data Center subnets.
Which one of the following commands is most likely to show you all the possible next - hop IP addresses for these four possible routes?（）

单项选择题A company has a Frame Relay WAN with one central - site router and 100 branch office routers. A partial mesh of PVCs exists: one PVC between the central site and each of the 100 branch routers. Which of the following could be true about the number of EIGRP neighbor ships?（）

A. A partial mesh totaling 100: one between the central - site router and each of the 100 branches.
B. A full mesh  -  (101 * 100) / 2 = 5050 - One neighborship between each pair of routers.
C. 101 - One between each router (including the central site) a nd its nearby PE router.
D. None of the answers is correct.

多项选择题Refer to the exhibit. Which two statements are true about the partial configuration that is shown? （）

A. The first DHCP client to connect to the FastEthernet 0/1 interface will receive the IP address 10.10.0.1.
B. DHCP requests received on the FastEthernet 0/1 interface will be forwarded to 10.0.0.2.
C. The first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP a ddress 10.0.0.1
D. The first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP address 10.0.0.6.
E. Hosts connected to the FastEthernet0/1 interface will not receive DHCP replies from the router.

多项选择题Which three of the following protocols will be forwarded to a host specified by the ip helper - address interface configuration command if the configuration has not been modified by the ip forward - protocol udp global con figuration command?（）

A. BOOTP
B. TFTP
C. ARP
D. DNS
E. proxy - ARP
F. FTP

单项选择题Refer to the exhibit. Routers R1 and R2 have established a neighbor relationship and are exchanging routing information. The network design requires that R1 r eceive routing updates from R2, but not advertise any routes to R2. Which configuration command sequence will successfully accomplish this task? （）

A. R1(config)# router eigrp 1   R1(config - router)# passive - interface serial 0
B. R1(config)# access - list 2 0 deny any   R1(config)# router eigrp 1   R1(config - router)# distribute - list 20 out serial 0
C. R2(config)# access - list 20 permit any   R2(config)# router eigrp 1   R2(config - router)# distribute - list 20 in serial 0
D. R1(config)# access - list 20 permit any   R 1(config)# router eigrp 1   R1(config - router)# distribute - list 20 in serial 0
E. R2(config)# access - list 20 deny any   R2(config)# router eigrp 1   R2(config - router)# distribute - list 20 out serial 0
F. R2(config)# router eigrp 1   R2(config - router)# passive - interface serial 0

多项选择题When policy - based routing (PBR) is being configured, which three criteria can the set command specify?（）

A. all interfaces in the path toward the destination
B. all networks in the path toward the destination
C. adjacent next hop router in the path toward the destination
D. all routers in the path toward the destination
E. all interfaces through which the packets can be routed
F. type of service and precedence in the IP packets