A:1100; B:1200; C:1250.
单项选择题当车间发生电气失火时,首先应该()。
A.使用泡沫灭火机 B.切断电源 C.检查失火原因 D.监测火情
单项选择题高速钢刀具淬火后若出现晶粒粗大,碳化物呈角状趋势或沿边界呈网状分布,这种缺陷称为()。
A.过热 B.过烧 C.腐蚀 D.荼状断口
单项选择题由于加热温度太高,沿奥氏体晶界面上发生的氧化或熔化现象称为()。
A.过热 B.过烧
单项选择题滴注式气体软氮化常用渗剂为()。
A.煤油 B.甲酰胺+尿素 C.甲醇 D.上述都不行
单项选择题生产中所说的水淬油冷属于()。
A.双液淬火 B.分级淬火 C.延时淬火
单项选择题盐水溶液在碳钢过冷奥氏体不稳定区(500~600℃)的冷却能力比水大的原因是()。
A.在红热工件表面析出的盐立即爆炸,将蒸气膜破坏的缘故 B.在水中加入氯化钠后便不会形成蒸气膜 C.淬火时由于盐的爆炸加快了对流
单项选择题当皮肤溅上强酸、强碱时的安全处理方法是()。
A.迅速擦掉 B.擦掉后冲洗 C.用大量清水冲洗
单项选择题水作为淬火介质,其温度越高,则冷却能力()。
A.越大 B.越小 C.与与温度无关
单项选择题淬火用水温一般控制在()。
A.0~15℃ B.15~30℃ C.35~70℃ D.70℃以上
单项选择题组织应力引起工件的变形的规律是()。
A.立方体平面凸起,棱角变圆 B.立方体平面凹陷,棱角不变 C.立方体平面凹陷,棱角变尖