单项选择题

Refer to the exhibit. What statement is true of the con……

Refer to the exhibit. What statement is true of the configuration for this network?（）

A.The configuration that is shown provides inadequate outside address space for translation of the number of inside addresses that are supported.
B.Because of the addressing on interface FastEthernet0/1, the Serial0/0 interface address will not support the NAT configuration as shown.
C.The number 1 referred to in the ip nat inside souce command recerences access-list number 1.
D.ExternalRouter must be configured with static routers to network 172.16.2.0/24

<上一题目录下一题>

热门试题

单项选择题Which type of EIGRP route entry describes a feasible successor?（）

A.a primary route,stored in the routing table
B.a backup route,stored in the routing table
C.a backup route,stored in the topology table
D.a primary route,stored in the topology table

单项选择题Which command shows your active Telnet connections?（）

A.show session
B.show cdp neighbors
C.show users
D.show queue

单项选择题What is the default maximum number of equal-cost paths that can be placed into the routing of a cisco OSPF router?（）

A.16
B.2
C.unlimited
D.4

单项选择题A router receives information about network 192.168.10.0 24 from multiple sources.What will the router consider the most reliable information about the path to that network?（）

A.an OSPF update for network 192.168.0.0/16
B.a static router to network 192.168.10.0/24 B.a static router to network 192.168.10.0/24 with a local serial interface configured as the next hop
C.a RIP update for network 192.168.10.0/24
D.a directly connected interface with an address of 192.168.10.254/24
E.a default route with a next hop address of 192.168.10.1

多项选择题Which commands are required to properly configure a router to run OSPF and to add network 192.168.16.0 24 to OSPF area 0?（）

A.Router(config)#router ospf 1
B.Router(config)#router ospf 0
C.Router(config)#router ospf area 0
D.Router(config-router)#network 192.168.16.0 0.0.0.255 area 0
E.Router(config-router)#network 192.168.16.0 0.0.0.255 0
F.Router(config-router)#network 192.168.16.0 255.255.255.0 area 0