单项选择题

A. Missing control VLAN in VSM configurationB. Missing ……

The network administrator is adding a new N1Kv to the vCenter， however， the administrator does not see the new switch under the networking tab of vCenter.

The administrator issues the following command on the VSM to troubleshoot：

VSM# show svs connections
connection VC：
ip address： 10.10.10.30
remote port： 80
protocol： vmware-vim https
certificatE. default
datacenter namE. DC1
DVS uuiD. 67 32 30 50 a6 d2 49 64-9e 1c 5f 49 e3 af 55 99
config status： Disabled
operational status： Disconnected sync status： -
version： -

When attempting to fix the issue， the following error is seen：

VSM-PRI-188# conf

VSM-PRI-188（config）# svs connection VC
VSM-PRI-188（config-svs-conn）# connect
ERROR： [VMWARE-VIM] Extension key was not registered before its use

What is the cause of the error？（）

A. Missing control VLAN in VSM configuration
B. Missing packet VLAN in VSM configuration
C. VSM has no network connection to vCenter
D. VSM extension key is not installed on vCenter
E. vCenter extension key is not installed on VSM

<上一题目录下一题>

热门试题

单项选择题Given the following configuration： port-profile type ethernet DATA-UPLINK vmware port-group switchport trunk allowed vlan 1-3967，4048-4093 channel-group auto mode on no shutdown state enabled port-profile type ethernet MGMT-UPLINK vmware port-group switchport trunk allowed vlan 10-12 channel-group auto mode on no shutdown state enabled VEMs are seen to be joining and then are lost from the Cisco VSM. How would you resolve this issue？（）

A. Remove second NIC from each port profile
B. Remove VEM from VSM （no vem X）， remove NICs， and reinsert
C. Ensure that VLANs on uplink profiles are not overlapping
D. Reinstall VEM
E. Issue the command "module vem X execute vemcmd set pinning module vsm 1"

单项选择题WhatistheuseofERSPANonN1kv？（）

A. Send monitored traffic to a VLAN
B. Send monitored traffic to a remote VEM over L2
C. Receive monitored traffic on a vEthernet interface
D. Send monitored traffic to an IP destination

多项选择题WhichstatementsarevalidforalocalSPANconfiguration？（）

A. Source and destination interface must be on the same host
B. Source and destination interfaces can be on different hosts
C. Destination vEthernet interface can be on a different VLAN than the source
D. Destination interface can be a physical port
E. Destination interface cannot be a physical port

多项选择题Given a host with two NICs assigned to a N1k profile，which topologies are suitable for this type of configuration （） port-profile type Ethernet name VM-Data vmware port-group switchport mode trunk switchport allowed vlan 400-410 channel-group auto mode active no shut state enabled

A. Cisco UCS fabric interconnects
B. Pair of N5K’s in VPC
C. Standalone N5K
D. Pair of N5K’s in non-VPC
E. Cisco Catalyst 6000 Switch in VSS

多项选择题A customer would like to monitor traffic that is being sent to a specific virtual machine named VM001 using SPAN. The customer has another virtual machine configured as a sniffer host called VM002. What configuration is required， and what other changes will need to be made？（） VSM-PRI-188# sh int vethernet 5 Vethernet5 is up Port description is VM001， Network Adapter 2 HardwarE. Virtual， address： 0050.56b0.001e （bia 0050.56b0.001e） Owner is VM VM001 ， adapter is Network Adapter 2 Active on module 5 VMware DVS port 484 Port-Profile is VM-vlan-10 Port mode is access VSM-PRI-188# sh int vethernet 6 Vethernet6 is up Port description is VM002， Network Adapter 1 HardwarE. Virtual， address： 0050.56b0.0020 （bia 0050.56b0.0020） Owner is VM VM002 ， adapter is Network Adapter 1 Active on module 5 VMware DVS port 485 Port-Profile is VM-vlan-10 Port mode is access

A. Monitor session 1 type span       Source interface veth5 both      Destination interface veth6      No shut
B. monitor session 1     source vlan 10      destination interface veth6      no shut
C. monitor session 1 type er-span      source interface vlan 10      destination ip 10.1.1.10      no shut
D. VM002 must be removed from the Nk1V
E. Move VM002 to Module 5
F. Restart the VEM on module 5