A、t B、h C、q D、I E、b F、z G、d H、P I、o J、k
单项选择题在高温、有尘、有毒等环境下工作的起重机,应设()司机室。露天工作的起重机,应设防风、防雨、防晒的司机室。
A、向外开 B、封闭式 C、开放式 D、向南开 E、向北开 F、向东开 G、向里开 H、向前开 I、向后开 J、向上开
单项选择题有防雷要求的起重机,大车轨道应直接接地,每侧大车轨道接地装置不少于()处。
A、一 B、二 C、三 D、四 E、五 F、六 G、七 H、八 I、九 J、十
单项选择题为起重机供电的同一低压电源系统中,不得出现一部分电气设备采取接零保护,另一部分电气设备却采取()的情况。
A、过流保护 B、失压保护 C、接地保护 D、偏斜限制器 E、电源断相保护 F、锚定装置或铁鞋 G、超速保护 H、夹轨器 I、过压保护 J、欠压保护
单项选择题控制起重机机构运动的所有电气控制器,均应有零位和()。
单项选择题为起重机供电的同一低压电源系统中,不得出现一部分电气设备采取(),另一部分电气设备却采取接地保护的情况。
A、过流保护 B、失压保护 C、接零保护 D、偏斜限制器 E、电源断相保护 F、锚定装置或铁鞋 G、超速保护 H、夹轨器 I、过压保护 J、欠压保护
单项选择题在吊装、搬运等起重工程作业中,保证安全的各项措施通过信号来提示人们的注意,这种信号由特殊的装置给予反映出来,称为()。
A、过流保护 B、失压保护 C、接地保护 D、偏斜限制器 E、电源断相保护 F、信号保护装置 G、超速保护 H、夹轨器 I、过压保护 J、欠压保护
单项选择题起重机总电源()在司机室内应有明显的信号指示。根据需要应设置故障信号或报警信号。信号装置应设置司机室或有关人员视力、听力可及的地方。
A、自动复位 B、主令控制器 C、开合状态 D、变幅 E、起升 F、过流保护 G、超速保护 H、短路保护 I、过压保护 J、欠压保护
单项选择题保护零线架空敷设间距大于12m时,保护零线必须选择()。
A、不小于20平方毫米的绝缘铜线或不小于25平方毫米的绝缘铝线 B、不小于10平方毫米的绝缘铜线或不小于20平方毫米的绝缘铝线 C、不小于16平方毫米的绝缘铜线或不小于25平方毫米的绝缘铝线 D、不小于10平方毫米的绝缘铜线或不小于16平方毫米的绝缘铝线 E、不小于6平方毫米的绝缘铜线或不小于25平方毫米的绝缘铝线 F、不小于6平方毫米的绝缘铜线或不小于20平方毫米的绝缘铝线 G、不小于12平方毫米的绝缘铜线或不小于25平方毫米的绝缘铝线 H、不小于12平方毫米的绝缘铜线或不小于15平方毫米的绝缘铝线 I、不小于8平方毫米的绝缘铜线或不小于25平方毫米的绝缘铝线 J、不小于1.6平方毫米的绝缘铜线或不小于2.5平方毫米的绝缘铝线
单项选择题安装架设场地的选择要保证与20~40KV输电线路的安全距离,沿水平方向最小不小于()m。
A、4.0 B、5.0 C、2.0 D、6.0 E、10 F、12 G、0.5 H、0.7 I、0.9 J、0.8
单项选择题起重机上宜设()来实现短路保护。
A、紧急断电开关 B、总断路器 C、失压保护 D、零压保护 E、防风装置 F、风速仪 G、夹轨器 H、铁靴 I、起重量限制器 J、放偏斜装置
单项选择题起重机上任何一点到电网中性点间的接地电阻最大应不大于()。
A、1 B、2 C、3 D、4 E、5 F、6 G、7 H、8 I、9 J、10
单项选择题起重机导线一般选用()电线、电缆。
A、塑料绝缘 B、聚乙烯绝缘 C、聚氯乙烯 D、双层绝缘 E、聚丙烯 F、橡胶绝缘 G、褐色橡胶 H、呢绒 I、铁芯 J、铝芯
单项选择题起重机必须采用()导线。
A、铜芯单股 B、铜芯多股 C、铝芯多股 D、铝芯单股 E、铅芯单股 F、铅芯多股 G、锌铝合金 H、黄铜 I、黑金属 J、有色金属
单项选择题起重电磁铁电路应符合以下要求()。
A、在直流起重机上应设专用的直流供电系统 B、必须使用交流电 C、必须有备用电源 D、在交流起重机上应设专用的直流供电系统 E、必须有专用供电系统 F、供电电压不小于50伏 G、供电电压不大于110伏 H、供电电压不大于36伏 I、起重机只能采用直流供电系统 J、环境温度不大于25度
单项选择题起重机采用采用多股多芯线时,截面积最小不得小于()平方毫米。
A、1.0 B、1.5 C、0.5 D、2.5 E、3.0 F、1.12 G、1.25 H、0.4 I、0.25 J、10