单项选择题

Exhibit： In this scenario the signal transmitted from t……

Exhibit：

In this scenario the signal transmitted from the AP is reflected off a wall， resulting in multipathinterference at the client end （ClientA）. Which of the following statements is true？（）

A.The transmitted signal from the AP arrives at the client at slightly different times resulting inphase shifting
B.Multipath interference can be solved by using dual antennas
C.If signal 2 is close to 360 degrees out of phase with signal 1， the result is essentially zero signalor a dead spot in the WLAN
D.Multipath interference is less of an issue when using a DSSS technology because multipath isfrequency selective
E.If signal 1 is in phase with signal 2， the result is essentially zero signal or a dead spot in theWLAN
F.None of the other alternatives apply

<上一题目录下一题>

热门试题

单项选择题Exhibit： You work as a network technician. Please study the exhibit carefully. In this wireless network， theLAP （lightweight access point） attempts to register to a WLC （Wireless LAN Controller）. What kindof message is transmitted？（）

A.The lightweight access point will send Layer 2 and Layer 3 Lightweight Access Point （LWAPP）mode discovery request messages at the same time
B.The lightweight access point will send Layer 3 Lightweight Access Point （LWAPP） modediscovery request messages only
C.The lightweight access point will send Layer 2 Lightweight Access Point （LWAPP） mode discovery request messages. If the attempt fails， the LAP will try Layer 3 LWAPP WLC discovery
D.The lightweight access point will send Layer 2 Lightweight Access Point （LWAPP） modediscovery request messages only

单项选择题WhichstatementbestdescribesCiscosupervisorengineredundancyusingStatefulSwitchover？（）

A.Switchover ensures that Layer 2 through Layer 4 traffic is not interrupted
B.Redundancy requires BGP， OSPF， EIGRP， or IS-IS
C.Redundancy provides fast supervisor switchover for all Cisco Catalyst 6500 series switches
D.Switchover can be caused by clock synchronization failure between supervisors

多项选择题WhichtwocharacteristicsapplytoCiscoCatalyst6500SeriesSwitchsupervisorredundancyusingNSF？（）

A.independent of SSO
B.NSF combined with SSO enables supervisor engine load balancing
C.supported by RIPv2， OSPF， IS-IS， and EIGRP
D.supports IPv4 and IPv6 multicast
E.prevents route flapping
F.dependent on FIB tables

多项选择题CompanyhasaCatalyst6500andyouneedtoconfigureredundancybetweenthesupervisormodules.Withrouteprocessorredundancy（RPR+），theredundantsupervisorengineisfullyinitializedandconfigured，whichshortenstheswitchovertimeiftheactivesupervisorenginefails.WhichthreestatementsaretrueabouttheRPR+operationswhentheredundantsupervisorengineswitchedoverthefailedprimarysupervisorengine？（）

A.Static IP routes are maintained across a switchover because they are configured from entries inthe configuration file
B.Information about dynamic routing states， maintained on the active supervisor engine， issynchronized to the redundant supervisor engine and is transferred during the switchover
C.Information about dynamic routing states， maintained on the active supervisor engine， is notsynchronized to the redundant supervisor engine and is lost on switchover
D.The Forwarding Information Base （FIB） tables are cleared on a switchover. As a result， routedtraffic is interrupted until route tables reconverge
E.Static IP routes are cleared across a switchover and recreated from entries in the configurationfile on the redundant supervisor engine
F.The Forwarding Information Base （FIB） tables are maintained during the switchover. As aresult， routed traffic continues without any interruption when the failover occurs

多项选择题AnSVIhasbeenconfiguredonadevice.Whichtwostatementsaretrueaboutaswitchedvirtualinterface（SVI）？（）

A.An SVI is normally created for the default VLAN （VLAN1） to permit remote switchadministration
B.Multiple SVIs can be associated with a VLAN
C.SVI is another name for a routed port
D.An SVI is created by entering the no switchport command in interface configuration mode
E.An SVI provides a default gateway for a VLAN