填空题GB规定基准制是()和(),一般优先选用()
填空题国标规定:孔、轴配合优先采用基()制,当一光轴需与孔形成多种配合时,应选基()制。
填空题未注公差尺寸是指图样中只标注(),而不标注极限偏差或其他代号的尺寸。
填空题的轴配合,属于()制过渡配合。
填空题基准圆柱孔的基本尺寸30毫米,公差等级为7级,其代号写成()
填空题标准公差等级IT01与IT10相比,()的精度较低。
填空题基本尺寸60毫米,公差等级都为8级,基本偏差代号为n的基孔制过渡配合的轴,其代号写成()
填空题配合代号为φ50H10 js10的孔轴,已知IT10=0.100mm,其配合的极限间隙(或过盈)分别为Xmax=()、Ymax=-0.050mm。
填空题从IT01~IT18,公差等级逐渐(),标准公差值逐渐增大。
填空题尺寸公差带由()和()两因素决定。而位置是由基本偏差决定的,大小是由标准公差决定的。
填空题φ50H10的孔和φ50js10的轴,已知IT10=(),其ES=+0.100mm,EI=0mm,es=+0.050mm,ei=-0.050mm。
填空题国标规定基准孔的基本偏差代号为(),基轴制则为h。
填空题尺寸φ80JS8,已知IT8=46μm,则其最大极限尺寸是(),最小极限尺寸是()。
填空题常用尺寸段的标准公差的大小,随基本尺寸的增大而(),随公差等级的提高而减少。
填空题在同一尺寸段内,尽管基本尺寸不同,但只要公差等级相同,其标准公差值就()