A.严禁 B.必须 C.宜 D.不得
单项选择题易燃物质可能出现的最高浓度不超过()可划为非爆炸区域。
A.爆炸下限值的10% B.爆炸下限值 C.燃烧下限值 D.爆炸下限值的5%
单项选择题在爆炸性粉尘环境内,引燃温度组别为T11的无过负荷电气设备最高允许表面温度为(),有过负荷电气设备最高允许表面温度为()。
A.160℃、145℃ B.120℃、110℃ C.215℃、195℃ D.150℃、170℃
单项选择题在爆炸性气体危险区域为1区的场所内,电缆线路()有中间接头。
A.一般不得 B.严禁 C.不宜 D.可以
单项选择题在爆炸性气体环境中应采取防止爆炸的措施。对区域内易形成和积聚爆炸性气体混合物的地点设置自动测量仪器,当气体或蒸汽浓度接近爆炸下限值的()时,应能可靠地发出信号或切断电源。
A.50% B.75% C.80% D.40%
单项选择题爆炸性气体环境应根据爆炸性气体混合物出现的频繁程度和持续时间进行分区, 在正常运行时不可能出现爆炸性气体混合物的环境,或即使出现也仅是短时存在爆炸性气体混合物的环境 属于()区。
A.1 B.2 C.21 D.0
单项选择题在爆炸性气体环境:1区、2区内,引向低压鼠笼型感应电动机支线的长期允许载流量,不应小于电动机额定电流的()倍。
A.2 B.2.5 C.1.25 D.1.05
单项选择题爆炸性气体环境1区、2区内,导体允许载流量,不应小于熔断器熔体额定电流的()倍和断路器长延时过电流脱扣器额定电流的()倍。
A.2、2.5 B.1.25、1.25 C.1.25、2.5 D.2.5、2
单项选择题爆炸性气体环境中选用正压型电气设备及通风系统时,在电气设备及其通风系统运行中,其风压不应低于()。
A.50Pa B.150Pa C.200Pa D.250Pa
单项选择题爆炸性气体环境应根据爆炸性气体混合物出现的频繁程度和持续时间进行分区, 连续出现或长期出现爆炸性气体混合物的环境 属()区。
A.1 B.0 C.2 D.22
单项选择题当IT系统引出N线,线路标称电压为220/380V,配电线路发生第二次异相接地故障时保护电器应在()内切断故障回路,并符合式()的要求。式中Zs2--包括相线、N线和PE线在内的故障回路阻抗,Ω;Ia2--保护电器切断故障回路的动作电流,A;U0--相线对地标称电压,V。
A.0.4s,Zs2Ia2≤50V B. C.0.8s,Zs2Ia2≤2U0 D.0.8s,Zs2Ia2≤1/2U0
单项选择题当IT系统不引出N线,线路标称电压为220/380V,配电线路发生第二次异相接地故障时保护电器应在()内切断故障回路,并符合式()的要求。式中Zs2--包括相线和PE线在内的故障回路阻抗,Ω;Ia2--保护电器切断故障回路的动作电流,A;U0--相线对地标称电压,V。
单项选择题在IT系统的配电线路中,当发生第一次接地故障时,应由绝缘监视电器发出音响或灯光信号,其动作电流应符合式()的要求。式中RA--外露可导电部分的接地极电阻,Ω;Id2--相线和外露可导电部分间第一次短路故障的故障电流A,它计及泄漏电流和电气装置全部接地电阻值的影响;U0--相线对地标称电压,V
A.RAId2≤50V B.RAId2≤2U0 C.RAId2≤U0 D.RAId2≤100V
单项选择题TT系统配电线路接地故障保护的动作特性应符合下面()公式的要求。式中RA--外露可导电部分的接地电阻和PE线电阻,Ω;Ia2--保证保护电器切断故障回路的动作电流,A;U0--相线对地标称电压,V。
A.RAIa2≤50V B.RAIa2≤2U0 C.RAIa2≤U0 D.RAIa2≤100V
单项选择题TN系统配电线路接地故障保护的动作特性应符合下面()公式的要求。式中Zs2--接地故障回路的阻抗,Ω;Ia2--保证保护电器在规定的时间内自动切断故障回路的电流,A;U0--相线对地标称电压,V
A.Zs2Ia2≤50V B.Zs2Ia2≤2U0 C.Zs2Ia2≤U0 D.Zs2Ia2≤100V
单项选择题应急电源与正常电源之间必须采取()的措施。
A.并列运行的措施 B.防止并列运行的措施 C.自动切换 D.防止自动切换