多项选择题

AnSVIhasbeenconfiguredonadevice.Whichtwostatementsaretr……

An SVI has been configured on a device. Which two statements are true about a switched virtualinterface （SVI）？（）

A.An SVI is normally created for the default VLAN （VLAN1） to permit remote switchadministration
B.Multiple SVIs can be associated with a VLAN
C.SVI is another name for a routed port
D.An SVI is created by entering the no switchport command in interface configuration mode
E.An SVI provides a default gateway for a VLAN

<上一题目录下一题>

热门试题

单项选择题Intheeventthattwodevicesneedaccesstoacommonserver，buttheycannotcommunicatewitheachother，whichsecurityfeatureshouldbeconfiguredtomitigateattacksbetweenthesedevices？（）

A.private VLANs
B.port security
C.BPDU guard
D.dynamic ARP inspection
E.DHCP snooping

多项选择题WhatistrueaboutaccesscontrolonbridgedandroutedVLANtraffic？（）

A.Router ACLs can be applied to the input and output directions of a VLAN interface
B.Bridged ACLs can be applied to the input and output directions of a VLAN interface
C.Only router ACLs can be applied to a VLAN interface
D.VLAN maps and router ACLs can be used in combination
E.VLAN maps can be applied to a VLAN interfac

单项选择题SwitchSW1hasbeenconfiguredwithPrivateVLANs.WiththattypeofPVLANportshouldthedefaultgatewaybeconfigured？（）

A.Trunk
B.Isolated
C.Primary
D.Community
E.Promiscuous
F.None of the other alternatives apply

单项选择题Refer to the exhibit. The user who is connected to interface FastEthernet 0 1 is on VLAN 10 andcannot access network resources. On the basis of the information in the exhibit， which commandsequence would correct the problem？（）

A.SW1（config）# interface fastethernet 0/1   SW1（config-if）# no shut
B.SW1（config）# interface fastethernet 0/1   SW1（config-if）# switchport mode access   SW1（config-if）# switchport access vlan 10
C.SW1（config）# vlan 10   SW1（config-vlan）# state active
D.SW1（config）# interface fastethernet 0/1   SW1（config-if）# switchport mode access
E.SW1（config）# vlan 10   SW1（config-vlan）# no shut

单项选择题You work as a network Technician. A new workstation has consistently been unable to obtain anIP address from the DHCP server when the workstation boots. Older workstations function normally， and the new workstation obtains an address when manually forced to renew its address. What should be configured on the switch to allow the workstation to obtain an IP address at boot？（）

A.UplinkFast on the switch port connected to the server
B.BackboneFast on the switch port connected to the server
C.PortFast on the switch port connected to the workstation
D.trunking on the switch