单项选择题

Refer to the exhibit. Why has this switch not been elec……

Refer to the exhibit. Why has this switch not been elected the root bridge for VLAN1?（）

A.It has more than one interface that is connected to the root network segment.
B.It is running RSTP while the elected root bridge is running 802.1d spanning tree.
C.It has a higher MAC address than the elected root bridge.
D.It has a higher bridge ID than the elected root bridge.

<上一题目录下一题>

热门试题

单项选择题Why will a switch never learn a broadcast address?（）

A.Broadcast frames are never sent to swiches.
B.Broadcast addresses use an incorrect format for the switching table.
C.A broadcast address will never be the source address of a frame.
D.Broadcasts only use network layer addressing.
E.A broadcast frame is never forwarded by a switch.

单项选择题Refer to the exhibit. Given the output shown from this Cisco Catalyst 2950, what is the most likely reason that interface FastEthernet 0 10 is not the root port for VLAN 2?（）

A.This switch has more than one interface connected to the root network segment in VLAN 2.
B.This switch is running RSTP while the elected designated switch is running 802.1d Spanning Tree.
C.This switch interface has a higher path cost to the root bridge than another in the topology.
D.This switch has a lower bridge ID for VLAN 2 than the elected designated switch.

单项选择题Refer to the exhibit.All switch ports are assigned to the correct VLANs, but none of the hosts connected to SwitchA can communicate with hosts in the same VLAN connected to SwitchB. Based on the output shown, what is the most likely problem?（）

A.The access link needs to be configured in multiple VLANs.
B.The link between the switches is configured in the wrong VLAN.
C.The link between the switches needs to be configured as a trunk.
D.VTP is not configured to carry VLAN information between the switches.
E.Switch IP addresses must be configured in order for traffic to be forwarded between the switches

多项选择题Which of the following statements describe the network shown in the graphic? （）

A.There are two broadcast domains in the network.
B.There are four broadcast domains in the network.
C.There are six broadcast domains in the network.
D.There are four collision domains in the network.
E.There are five collision domains in the network.
F.There are seven collision domains in the network.

单项选择题Which command enables RSTP on a switch?（）

A.spanning-tree mode rapid-pvst
B.spanning-tree uplinkfast
C.spanning-tree backbonefast
D.spanning-tree mode mst